Aluminium 25mm Venetian Blind

*Colour

-- Please Select --Alabaster Bone Créam Earl Grey Metalic Sterling Storm Night Tea White

Measurement (mm)

*Width

Measure the width Measure the width side-to-side of the exact window frame opening in three places (top, middle, bottom). Please provide the smallest of these three measurements and round down to nearest 1/8 inch. Please note that for an inside mount blind, Blinds to Go recommends a standard deduction of 3/8” (0.375”) on the dimension of the window. This standard deduction permits the blind and the brackets to be installed in the window.

Obstructions may cause measurements to vary. Make sure to note them when measuring. Important: Measure the depth of any protruding sill, ledge or molding that may interfere with the hanging of your blind. Protruding heaters, frames, locks, handles, sills etc. may interfere with your measurements. Please indicate them when measuring your window frame. Remember: To ensure accurate measurements, use only a high quality, steel tape measure with a wide blade (minimum 1/2”). Tell your Sales Associate about any obstructions inside your window frame (locks, screens, doorknobs, handles, radiators, plants, etc.). Provide all measurements to the nearest 1/8”. Required minimum depth: Min depth needed: 1 1/2", Full recess depth: 3 1/4”

*Height

Measure the height For inside mount: Measure the HEIGHT (top-to-bottom) of the exact window frame opening in three places (left, center, right). Please provide the LARGEST of these three measurements. For outside mount: Measure from frame to frame. we recommend to add 2" to the height for wall installation.

Obstructions may cause measurements to vary. Make sure to note them when measuring. Important: Measure the depth of any protruding sill, ledge or molding that may interfere with the hanging of your blind. Protruding heaters, frames, locks, handles, sills etc. may interfere with your measurements. Please indicate them when measuring your window frame. Remember: To ensure accurate measurements, use only a high quality, steel tape measure with a wide blade (minimum 1/2”). Tell your Sales Associate about any obstructions inside your window frame (locks, screens, doorknobs, handles, radiators, plants, etc.). Provide all measurements to the nearest 1/8”. Required minimum depth: min depth needed is 1 1/2" and for full recess you need 3 1/4”

*Fit Location

-- Please Select --Inside Mount Outside Mount

*Control Side

-- Please Select --Left Right

*Control length (mm)

Min: 400mm Max: 2000mm

-- Please Select --400 500 600 700 800 900 1000 1100 1200 1300 1400 1500 1600 1700 1800 1900 2000

*Location of blind (room)

* Required Fields