Faux & wooden venetian blinds install guides

Step 1

1 x LH bracket

2 x screws

Fix the back of the left bracket (labeled LH) 80mm from the front of the top left-hand corner of the window using the two screws provided.

Step 2

1 x RH bracket

2 x screws

Fix the right bracket (labeled RH) inside the window frame in the top right-hand corner of the window in the same manner. Ensure that the back of the right bracket is in line with the back of the left bracket.

Step 3

Centre brackets (if supplied)

Screws (if supplied)

If the blind includes centre brackets space them evenly between the end brackets being careful to ensure that they do not line up with the strings in the top of the blind when installed.

Ensure that the backs of the centre brackets are in line with the back of the left and right brackets.

Step 4

Remove the control cord bundle from the top of the headrail, leaving the fabric ties that hold the blind together.

Step 5

Open the end bracket latches and place the headrail into the brackets, keeping your control cords on the correct side.

Close the latches firmly and ensure they ‘click’ closed.

Step 6

1 x pelmet Velcro tabs

Peel the tape off the Velcro tabs attached to the headrail. Position the pelmet level with the top of the blind and attach by pressing firmly against the Velcro tabs.

Step 7

While holding the blind in place, carefully untie the fabric straps.

Step 1

1 x LH bracket

2 x screws

At the position originally measured from, fix the left bracket (labelled LH) to the architrave or wall using two of the screws provided.

Tips: If positioning near the edge of the frame/architrave, pre-drill the holes to prevent splitting. If fixing to the wall you may need to pack out the brackets and use longer screws to allow the blind to clear the window reveal when installed.

Step 2

1 x RH bracket

2 x screws

Repeat step 1 but on the right side using the bracket labelled RH.

Step 3

Centre brackets (if supplied)

Screws (if supplied)

If the blind includes centre brackets, space them evenly between the two end brackets being careful they do not line up with the strings in the top of the blind when installed.

Step 4

Remove the control cord bundle from the top of the headrail, leaving the fabric ties that hold the blind together.

Step 5

Open the end bracket latches and place the headrail into the brackets, keeping your control cords on the correct side.

Close the latches firmly, ensuring they ‘click’ into place.

Step 6

1 x pelmet Velcro tabs

Peel the tape off the velcro tabs attached to the headrail. Position the pelmet level with the top of the blind and attach by pressing firmly against the velcro tabs.

Step 7

While holding the blind in place, carefully untie the fabric straps.